Creating A Wired Ethernet Connection Between Your Computer And The Ibm Gateway - IBM High Rate Wireless LAN Gateway Quick Start Manual

Creating a wired Ethernet connection between your
computer and the IBM Gateway
To connect your computer to the IBM High Rate Wireless LAN Gateway using
an RJ-45 Ethernet cable, do the following:
1. Attach an RJ-45 Category 5 Ethernet cable (not included) to one of the four
local Ethernet ports located on the rear of the Gateway.
2. Connect the other end of the RJ-45 Category 5 Ethernet cable to the
Ethernet port of your computer.
Step 3: Configure your computer's networking settings to
communicate with the IBM Gateway
To setup the networking properties of your computer to communicate with the
IBM Gateway, do the following:
Important
v If your network administrator configured your networking settings,
consult them before continuing the installation.
v Two different sets of instructions are provided; one for Microsoft
Windows 2000 and one for Microsoft Windows 95, Windows 98,
Windows 98 SE, and Windows Millennium Edition (Me).
IBM High Rate Wireless LAN Gateway Quick Start
1-5