IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual page 124

18. At each prompt, type the requested information and then press<enter>:
Site 1 – Server A
ID
1 (eth3)
2 (eth4)
Site 1 – Server B
ID
1 (eth3)
2 (eth4)
Site 2 – Server A
ID
1 (eth3)
88
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
You are prompted for the information for the second destination (target - eth4)
server and the local network.
Attention: Do not configure the replication ports Eth3 and Eth4 on the same
subnet as the external LAN port Eth0. Doing so may cause replication errors.
Please provide the following information:
Target Network Address:
(starting network address) (for example: 10.11.196.0)
Target Network Netmask:
(for example: 255.255.255.0)
Local Gateway Address:
(the gateway IP address of the server you are currently configuring) (for
example: 10.11.197.0)
An updated summary displays:
ID Target
Network Address
1 10.11.194.0
2 10.11.196.0
The addresses in the summary are examples. In this instance the term target
refers to the network address of the nodes at site 1 and site 2. Actual values
will vary. For reference, write the actual values from the summary screen in
the blank spaces below.
Depending on your replication configuration, the "remote node" Target
Network Address may be the same network starting address for Server A and
B if more than one node is replicating to a single node.
Target Network Address
(Remote node's starting
network address)
Target Network Address
(Remote node's starting
network address)
Target Network Address
(Remote node's starting
network address)
Target Netmask
255.255.255.0
255.255.255.0
Target Netmask
(Remote node's netmask)
Target Netmask
(Remote node's netmask)
Target Netmask
(Remote node's netmask)
Local Gateway
Address
10.11.195.1
10.11.197.1
Local Gateway Address
(The gateway address for
Server A at Site 1)
Local Gateway Address
(The gateway address for
Server B at Site 1)
Local Gateway Address
(The gateway address for
Server A at Site 2)