Protectier Manager Screen - IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual

Figure 25. ProtecTIER Manager screen
2. On the ProtecTIER Manager toolbar, click the
3. Enter the IP address of the node to be added, and then click Ok.
4. Click Login.
5. When prompted for login information, enter ptadmin for both the username
6. Go to "Planning the repository" on page 79.
78
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
Any configured networked systems are listed along with their IP addresses in
the Nodes section of the Navigation pane, and are available for login.
The Add node dialog displays and prompts you for the IP address and port
number of the node you want to add.
Note: Do not change the port number of the node unless directed to do so by
IBM Support.
The node appears in the Nodes pane and the Login button displays in the
View pane.
The Success dialog displays and provides information about the repository,
which is created in an upcoming procedure.
and password, and then click Ok.
ProtecTIER Manager displays the information for the added node. If the node
has an existing repository, the node's cluster displays on the Systems tab of the
Navigation pane. If the cluster contains a second node, that node displays in
the Nodes pane.
(Add Node) button.