Attaching The Mounting Brackets And Power - IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual

Figure 7. Attaching the mounting brackets and power cord
2. Attach the side rails to the server frame. To do so, working from the front side
3. Install the air duct housing in the frame. To do so, working from the front side
26
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
a. Attach the mounting brackets to the short-sides of the Ethernet switch,
making sure to align the perforated fan vents on the switch with the cut-out
areas on the brackets. See Figure 7.
b. Thread the power cord through the holes in the mounting bracket, making
sure that the tab extensions on the power cord are positioned on the outside
of the bracket.
c. Attach a protective grommet to the power cord, and fit the grommeted part
of the cord into the retention slot on the top of mounting bracket.
d. Plug the power cord into the power receptacle on the Ethernet switch.
e. Insert screws through the tab extensions on the power cord and into the
mounting bracket. Tighten the screws to attach the power cord to the
bracket.
f. Place the air baffle on top of the mounting bracket without the power cord
(the left side bracket in the above illustration). Do not screw the air baffle to
the mounting bracket.
g. Repeat the above steps for the other Ethernet switch.
of the frame:
a. Align the holes in the left side rail with the holes at positions 3 and 4 of the
frame. The guide pins on the side rail should point toward the back of the
server frame.
b. Insert one flanged screw into the hole at position 4 of the frame, tightening
the screw just enough to hold the rail in place.
c. Insert a second screw into the hole at position 3 of the frame, but do not
screw it in. Temporarily inserting this screw allows you to make sure that
both holes in the rail are properly aligned with both holes in the frame.
d. Tighten the screw in position 4, and then remove the temporary screw from
position 3.
e. Repeat the above steps for the right side rail and ensure that both side rails
are secure.
of the frame: