IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual page 123

2 10.11.196.0
Followed by the Available Options prompt:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
15. Type: a <enter>
You are prompted to enter information for the first destination (target - eth3)
server and the local network.
Attention: Do not configure the replication ports Eth3 and Eth4 on the same
subnet as the external LAN port Eth0. Doing so may cause replication errors.
16. At each prompt, type the requested information and then press <enter>:
Attention: In this step, the term "target" refers to the remote node's network
address and netmask (not necessarily the replication "target" server for this
entry.)
Please provide the following information:
Target Network Address:
(starting network address) (for example: 10.11.194.0)
Target Network Netmask:
(for example: 255.255.255.0)
Local Gateway Address:
(the gateway IP address of the server you are currently configuring) (for
example: 10.11.195.1)
A summary displays:
ID Target
Network Address
1 10.11.194.0
The addresses in the summary above are examples. Actual values will vary.
For example, if the Target Network Address for the destination server is
10.11.194.75, its starting address would be 10.11.194.0. For the Local Gateway
Address you would use the gateway address of the source server (this server).
The Available Options prompt displays a second time:
Available Options:
==================
(a)dd a new record
(e)dit a record
(d)elete a record
(c)ommit changes
(q)uit
Please Choose (a,e,d,c,q):
17. Type: a <enter>.
255.255.255.0 10.11.197.1
Target Netmask Local Gateway
Address
255.255.255.0 10.11.195.1
Chapter 12. Upgrading ProtecTIER to a cluster
87