Remote Supervisor Adapter Ii Refresh - IBM System Storage TS7600 ProtecTIER Series Installation Roadmap Manual

Figure 37. Remote Supervisor Adapter II Refresh 1 Welcome window
14. In the ASM section of the left-side navigation pane of the Remote Supervisor
15. In the Static IP Address field, change the last octet to an address value that is
16. In the Netmask field, enter: 255.255.255.0.
17. Leave the Gateway field blank.
18. Click Save.
19. Read the alert and then click OK to continue.
20. Close the ASM window.
21. On the TSSC or service laptop, open a browser window.
22. In the Address Bar area of the browser window, type the unique RSA IP
23. In the Login window, enter USERID as the username and PASSW0RD (with a
116
IBM System Storage TS7600 with ProtecTIER: Installation Roadmap Guide
You are now logged into the server's RSA.
c. Do one of the following, as appropriate:
v If you are altering the default IP address of the RSA on Server B to
avoid an IP address conflict, continue with step 14.
v If you are connecting to the RSA to establish a command line interface
to a stand-alone server, or either server in a cluster, skip the remaining
steps in this procedure and go to "Enabling Remote Control" on page
117.
Adapter II Refresh 1 Welcome window, click Network Interface.
lower than the default of 254.
For example: 172.31.1.253.
An Alert dialog opens.
The RSA IP address on Server B is now unique.
address that you set in step 15 and then press <enter>.
zero) as the password, and then click OK.
Note: The username and password are case sensitive and must be entered in
all uppercase.
The Remote Supervisor Adapter II Refresh 1 Welcome window opens.