Advertisement
6
Installing the power cables
6.1
6.2
6.3
Make sure all power supply switches on the N7700/N7900(s) and any
attached expansion units(s) are in the Off position.
Connect the power cords to all
power receptacles for all storage systems that are being installed
using power cord retainer clips as shown below.
Connect the power cords to the power sources, making sure that the
power supplies on the left and right sides of the system are connected
to separate and independent AC power sources.
redundant power.
Caution:
Do not power on the system at this time.
Give all documentation (including this document) and all hardware to the
customer.
Note:
Refer the customer to the next two pages for additional
planning and setup information.
power supply 1 and power supply 2
This ensures
6.1
13
Advertisement
