Smartgen HGM8156 User Manual page 27

No. Items
Difference
Phase Angle
5
Difference
Difference
6
Frequency
7 MSC ID
8 MSC Priority
9 Baud Rate
10 MSC Modules
MSC Too
11
Modules Action
12 Load Mode Control
13 Output Active Power
14 Reactive Control
Reactive Control
15
Amplitude
16 MSC Modules
MSC Too
17
Modules Action
18 Start Request Delay
19 Fail to Sync Delay
20 Fail to Sync Action
21 Sync Gain
22 Sync Stability
Active Power
23
Control Gain
Active Power
24
Control Stability
HGM8156 Genset Parallel (With Mains) Controller
HGM8156 GENSET PARALLEL CONTROLLER USER MANUAL
Range
(0-20)°
(0-1.00)Hz
(0-31)
(0-31)
(0-3)
(1-32)
Few
(0-2)
(0-2)
(-100-100.0)%
(0-1)
(0-100.0)%
(0-32)
Few
(0-2)
(0-3600)s
(5.0-300.0) s
(0-1)
(0-500)%
(0-2000)%
(0-500)%
(0-2000)%
Defaults
difference but above negative difference.
It is considered phase synchronization when
the initial phase difference between gen and
10
bus is lower than synchronizing phase angle
difference.
Frequency difference of adjusting gen
0.10
frequency to be above mains freq.
ID indication
1 network, MSC ID shall be unique in the
whole communication network.
0 Smaller the number is, higher the priority is.
0: 500 kBit/s；
1: 250 kBit/s；
1
2: 125 kBit/s；
3: 50 kBit/s.
2
Action:
0: None
1
1: Warn
2: Trip
0: Bus Control Mode
0 1: Mains Control Mode
2: Load Receipt Mode
Used for load control
30.0
0: Reactive power control
0
1: Power factor control
Used for load control
8.0
If least started genset number is not
1
detected during the delay, it will issues alarm
1
based on pre-set alarm action.
Action
120
60.0 If sync signal is not detected during the
delay, it will it will issues alarm based on
0 pre-set alarm action.
Action
20 Regulate and control before parallel;
20 Regulate and control before parallel;
20 Regulate and control after parallel;
20 Regulate and control after parallel;
2019-09-10
Description
of MSC communication
0: None 1: Warn 2: Trip
0: Warn 1: Trip
Version 1.1 Page 27 of 44