Hat Rails; Hat Rail Adapter, Tightening Torques - Festo CPV -VI Series Manual

2. Fitting
2−10
Proceed as follows:
Make sure that the fastening surface can support the
·
weight of the CPV valve terminal.
Fit the following hat rail:
·
Hat rail for CPV10/14
valve terminal
Support rail DIN 50022 − 35x7.5;
width 35 mm, height 7.5 mm)
Tab. 2/6:

Hat rails

Make sure that there is sufficient space for connecting the
·
supply cables and tubing, and that extra space is avail
able for fitting CPV valve terminals with large surface−
mounted silencers.
Fasten the hat rail to the fastening surface approximately
·
every 100 mm.
Fasten the two brackets to the end plates with the screws
·
supplied as shown in the diagram below. With CPV10/14
valve terminals, make sure that the fastening bolts of the
brackets grip into the recess in the CPV valve terminal.
CPV valve
terminal
CPV10/14
CPV18
Tab. 2/7:

Hat rail adapter, tightening torques

Hat rail for CPV18
valve terminal
Support rail DIN 50022 − 35x15
(width 35 mm, height 15 mm)
Self−threading
screw
M4x10
M5x10
Festo P.BE−CPV−EN en 0503g
Tightening torque
1.5 Nm
4 Nm