Diagnostics Via Led Operating Display - Siemens SIMATIC RF600 System Manual

System diagnostics
9.1 Diagnostics via the LED displays of the reader
9.1.2

Diagnostics via LED operating display

The operating states of the reader are displayed by the "RUN/STOP", "ERROR",
"MAINTENANCE" and "PRESENCE" LEDs. The LEDs can adopt the colors green, red or
yellow and the statuses off , on
Table 9- 1 Display of operating statuses
R/S ER
--
--
-- --
-- --
-- --
Not present on the RF650R.
1)
Not present on the RF680R/RF685R.
2)
--: Not relevant
472
MAINT PRE Meaning
1) 2)
The device is turned off.
The device is starting up.
-- -- The device is ready for operation. The connection to the application
(XML, OPC UA, controller) is not established.
There may be an error.
-- -- The device is ready for operation but there is an error.
-- -- The device is ready for operation. The connection to the application
(XML, OPC UA, controller) is established.
-- -- The device is working.
•
•
•
Flash test for reader identification.
-- -- There is an error. You will find more information on error messages in
the section "XML/PLC error messages (Page 473)".
-- -- The network load too high. The functioning of the device is being dis-
turbed due to receiving too many network packets.
-- The antenna is switched on. There is no transponder in the antenna
field.
-- There is at least one transponder in the antenna field.
-- One or more transponders have been detected as valid.
, flashing :
STEP 7, Ethernet/IP: The "writeconfig" command was received.
XML application: The "hostGreeting" command was received.
OPC UA: Connection to the client is established.
System Manual, 06/2019, J31069-D0171-U001-A22-7618
SIMATIC RF600