Dimension Drawing - Siemens SIMATIC RF600 System Manual

Readers
5.6 SIMATIC RF685R
Standards, specifications, approvals
Proof of suitability
MTBF
Measured at the output of the antenna socket.
1)
All supply and signal voltages must be safety extra low voltage (SELV/PELV according to
2)
EN 60950). The voltage sources must meet the requirements of limited power sources (LPS) and
NEC Class 2.
Note that, depending on the power consumption, using extension cables > 20 m (6GT2891-4FN50)
may lead to a voltage drop on the reader. This voltage drop can mean that the necessary mini-
mum voltage on the reader is below the required 20 V.
Keep to the switching schemes of the DI/DQ interface.
3)
The values for shock and vibration are maximum values and must not be applied continuously.
4)
These values only apply to mounting using screws.
5.6.6

Dimension drawing

Figure 5-49
All dimensions in mm (± 0.5 mm tolerance)
224
Dimension drawing RF685R
EN 301 489-1 V1.9.2 / EN 301 489-3 V1.6.1 /
EN 302 208-1/-3 V1.4.1
FCC CFR 47, Part 15 section 15.247
29 years
System Manual, 06/2019, J31069-D0171-U001-A22-7618
6GT2811-6CA10-xAA0
SIMATIC RF600