Bending Radii And Bending Cycles Of The Cable; Antenna Parameter Assignment; Setting Rf640A Parameters For Rf650R - Siemens SIMATIC RF600 System Manual

Antennas
6.4 SIMATIC RF640A
6.4.4.1

Bending radii and bending cycles of the cable

The following listed bending radii are minimum values, which may not be fallen below and
are based on repeated bending.
Table 6- 18
Cable designa-
tion
Antenna cable
Antenna cable
Antenna cable
(suitable for drag
chains)
Antenna cable
Antenna cable
Antenna cable
(suitable for drag
chains)
Antenna cable
Antenna cable
Permissible minimum bending radius with one-time bending. 28 mm
1)
With cables capable of being used in drag chains, 100,000 bending cycles at a bending radius of
2)
100 mm and a bend of ± 180° or 3 million torsion cycles with a bend of ± 180° on a cable length of
1 m are permitted.
6.4.5

Antenna parameter assignment

6.4.5.1

Setting RF640A parameters for RF650R

Depending on the country or region in which the antenna is being operated, it is subject to
regional limitations with respect to the radiated power.
Limitations in the EU, EFTA, or Turkey
Note
Limitation of the radiated power according to EN 302 208 V1.4.1 (ETSI)
RF600 systems that are put into operation in the EU, EFTA or Turkey must not exceed the
following radiated power with an RF640A antenna:
• 2000 mW ERP (or 33 dBm ERP)
Converted into EIRP: 3250 mW EIRP (or 35 dBm EIRP)
274
Bending radii of the antenna cable
Article number
6GT2815-0BH10
6GT2815-0BH30
6GT2815-2BH50
6GT2815-1BN10
6GT2815-0BN10
6GT2815-2BN15
6GT2815-0BN20
6GT2815-0BN40
Length [m] Cable loss [dB]
1 0.5
3 1
5 1.5
10 2
10 4
15 4
20 4
40 5
System Manual, 06/2019, J31069-D0171-U001-A22-7618
Bending radius
[mm]
51
51
45
1) 2)
77
51
45
1) 2)
77
77
SIMATIC RF600