Antenna Parameter Assignment - Siemens SIMATIC RF600 System Manual

Cable designa-
tion
Antenna cable
Antenna cable
Antenna cable
(suitable for drag
chains)
Antenna cable
Antenna cable
Permissible minimum bending radius with one-time bending. 28 mm
1)
With cables capable of being used in drag chains, 100,000 bending cycles at a bending radius of
2)
100 mm and a bend of ± 180° or 3 million torsion cycles with a bend of ± 180° on a cable length of
1 m are permitted.
6.3.5

Antenna parameter assignment

Depending on the country or region in which the antenna is being operated, it is subject to
regional limitations with respect to the radiated power.
Limitations in the EU, EFTA, or Turkey
Note
Limitation of the radiated power according to EN 302 208 V1.4.1 (ETSI)
RF600 systems that are put into operation in the EU, EFTA or Turkey must not exceed the
following radiated power with an RF620A antenna:
• 500 mW ERP (or 27 dBm ERP)
Converted into EIRP: 820 mW EIRP (or 29 dBm EIRP)
Make the following settings to ensure that the maximum permitted radiated power of the
antenna is not exceeded:
● Antenna gain: -5 dBi
● Radiated power: ≤ 340 mW ERP (or 25.35 dBm ERP)
Converted into EIRP: ≤ 560 mW EIRP (or 27.5 dBm EIRP)
● Use of cable loss associated with the antenna cable.
SIMATIC RF600
System Manual, 06/2019, J31069-D0171-U001-A22-7618
Article number Length [m]
6GT2815-1BN10 10
6GT2815-0BN10 10
6GT2815-2BN15 15
6GT2815-0BN20 20
6GT2815-0BN40 40
6.3 SIMATIC RF620A
Cable loss [dB] Bending radius
[mm]
2 77
4 51
4 45
1) 2)
4 77
5 77
Antennas
255