NEC Aspire Series Networking Manual page 141

Dial Types
0
1
2
3
4
5
6
8
Networking
Step 2: Specify the length of the code you want to change
After you specify a single or two digit code, you must tell the system how many digits com-
prise the code. This is the Number of Digits Required column in the System Numbering
(page 133) table. In the default program, all codes from 100-999 are three digits long. Codes
beginning with 0 are one digit long. Codes beginning with * are 3 digits long and codes begin-
ning with # are 4 digits long.
Step 3: Assign a function to the code selected
After entering a code and specifying its length, you must assign its function. This is the Dial
Type column in the System Numbering (page 133) table. The choices are:
Dial Type Description
- Not Used -
Service Code
Extension Number
Trunk Access Code
Special Trunk Access
Operator Access
ARS/F-Route Access
Networking
11-01 : System Numbering
Related Program
11-10 : Service Code Setup (for System Administrator)
11-11 : Service Code Setup (for Registration)
11-12 : Service Code Setup (for Service Access)
11-13 : Service Code Setup (for ACD)
11-14 : Service Code Setup (for Hotel/Motel)
11-15 : Service Code Setup (Special access)
11-02 : Extension Numbers
11-04 : Virtual Extension Numbers
11-06 : 2PGDAD (ACI) Extension Numbers
11-07 : Department Calling Group Numbers
11-08 : 2PGDAD (ACI) Group Pilot Numbers
11-09 : Trunk Access Code
11-09 : Trunk Access Code
20-17 : Operator's Extension
44-xx
10-03 : PCB Setup
10-12 : NTCPU Network Setup
10-20 : LAN Setup for External Equipment
10-27 : IP System IP
Programming
◆ 131