Feature Cross Reference; Telephone Programming Instructions - NEC Aspire Series Networking Manual

Programming
10-03 : PCB Setup
Conditions

Feature Cross Reference

Telephone Programming Instructions

118 ◆
(A.) When changing a deÞned terminal type, Þrst set the type to '0' and then plug the new device in
to have the system automatically deÞne it or redeÞne the type manually.
(B.) The system must have a PCB installed in order to view/change the options for that type of
PCB.
None
To enter data for Program 10-03 (PCB Setup):
1. Enter the programming mode.
2. 10 03
10-02-01 Slot No 1
ESIport01 CH1 1 :TEL |1
↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓
back
3. Enter the number of the item you want to program.
10-02-nn Slot No 1
nnnnn
↑ ↑ ↑ ↑ ↓ ↓ ↓ ↓
back
4. Select a slot number to be programmed by pressing the VOLUME
Or, press FLASH once to select the slot number or press FLASH twice to select a port num-
ber. Enter the slot or port number.
5. Enter data for the item you selected + HOLD.
6. Enter data for the next item in the program.
OR
Press MSG once to enter a new item number.
OR
Press MSG until you've exited that series's programming section.
select
select
▲ ▼
or VOLUME keys.
Networking