NEC Aspire Series Networking Manual page 117

Use this keypad
digit . . .
1
2
3
4
5
6
7
8
9
0
*
#
CONF
CLEAR
Use this keypad
digit . . .
1
2
3
4
5
6
7
8
9
0
*
#
CONF
CLEAR
Networking
With Software 2.05+:
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
Enter characters A-C, a-c, 2.
Enter characters D-F, d-f, 3.
Enter characters G-I, g-i, 4.
Enter characters J-L, j-l, 5.
Enter characters M-O, m-o, 6.
Enter characters P-S, p-s, 7.
Enter characters T-V, t-v, 8.
Enter characters W-Z, w-z, 9.
Enter characters:
0 ! " #
Enter characters:
* + , -
# = Accepts an entry (only required if two letters on the same key are needed - ex: TOM).
Pressing # again = Space. (In system programming mode, use the right arrow soft key
instead to accept and/or add a space.)
Clear the character entry one character at a time.
Clear all the entries from the point of the ßashing cursor and to the right.
When using i-Series telephones on the Aspire system, not all the same characters are available.
Refer to the following chart for the i-Series characters:
Enter characters:
1 @ [ ¥ ] ^ _ ` { | }
blank blank blank
Enter characters A-C, a-c, 2.
Enter characters D-F, d-f, 3.
Enter characters G-I, g-i, 4.
Enter characters J-L, j-l, 5.
Enter characters M-O, m-o, 6.
Enter characters P-S, p-s, 7.
Enter characters T-V, t-v, 8.
Enter characters W-Z, w-z, 9.
Enter characters:
0 ! " #
Enter characters:
* + , -
# = Accepts an entry (only required if two letters on the same key are needed - ex: TOM).
Pressing # again = Space.
Clear the character entry one character at a time.
Clear all the entries from the point of the ßashing cursor and to the right.
When you want to. . .
→ → → → ← ← ← ←
$ % & ' ( ) ô Õ ú ä ö ü
. / : ; < = >
When you want to. . .
→ → → → ← ← ← ←
$ % & ' ( ) blank blank blank ä ö ü
. / : ; < = >
Programming
Programming Basics
Á À Â Ã Ç É Ê ì ó
α ε θ
σ
? π ∑ Ω ∞ ¢ £
å blank blank blank blank blank
σ
? π ∑ Ω ∞ ¢ £
α ε θ
◆ 107