NEC Aspire Series Networking Manual page 123

ISDN Line Number
Item
No.
01 ISDN Line Mode
02 Logical Port Number
(see Note 1)
03 Connection Type
04 Layer 3 Timer Type (see Note 2)
05 CLIP Information Announcement
Based on this setting, the system will
include a "Presentation Allowed" (1)
or "Presentation Restricted" (0) in the
Setup message to allow or deny the
Calling Party Number. Program
15-01-04 must also be set to a '1' if
this option is enabled.
06 Connection Bus Mode (S-point only)
07 S-point DID digits
08 Dial sending Mode
09 Dial Information Element
(Only for Overlap Sending Mode)
10 Master/Slave System (NW mode only)
Networking
For BRIU Unit
Item
0 = Not set
1 = T-Bus
2 = S-Bus
3 = Network Mode (Leased Line)
4 = Network Mode (Interconnected Line)
5 = Network Mode (Interconnected Line, Fixed layer 1=NT)
6 = S-Point (Leased Line)
0 = Net set
1 = For T-Bus (1-200)
0 = Point-to-Multipoint (not available for Networking)
1 = Point-to-Point
1-5
0 = Disable
1 = Enable
0 = Extended Passive Bus
1 = Short Passive Bus
0-4
0 = Enblock sending
1 = Overlap sending
0 = Keypad Facility
1 = Called Party Number
0 = Slave System
1 = Master System
Input Data
Options 3-5 determines the clock source
for the networked connection.
Telco sends the clock to the Master System
Telco sends the clock to the Slave System
Master System sends the clock to the Telco (or direct
connection without telco) which then sends the clock
to the Slave System
Master System sends the clock to the Telco
Slave System sends the clock to the Telco
2 = For S-Bus (Through Software 3.07: 0-256
From Software 4.0E+: 0-384)
Programming
10-03 : PCB Setup
01-08
Default
◆ 113
1
0
0
1
1
0
0
1
0
0