NEC Aspire Series Networking Manual page 126

Programming
10-03 : PCB Setup
Item
No.
13 Loss-Of-Signal detection limit
14 Service Protocol for S-Point
15 Alert Tone When S-Bus Terminal
Calls Busy Extension
This option determines for S-Bus ter-
minals what a user on an S-Bus ter-
minal will hear when a busy
extension is called. If this option is
set to "0", the user will hear an alert
tone. If this option is set to "1", the
user will be disconnected.
16 ISDN 2 B-Channel Transfer
Enable or disable the 2 B-Channel
Transfer function for a PRI PCB.
18 Type of Number
Use this option to deÞne the ISDN
numbering plan to allow the calling
party information to be passed to
some telcos. Note that with soft-
ware 4.08-4.0W, Program 99-01-32
was used instead.
19 Numbering Plan IdentiÞcation
passed to some telcos. Note that
with software 4.08-4.0W, Program
99-01-33 was used instead.
116 ◆
Item
In short-haul mode
0 = Keypad Facility
1 = SpeciÞed Protocol for Aspire System
0 = Alert Tone
1 = Disconnected
0 = Off/Disable
1 = On/Enable
0 = Unknown
1 = International number
2 = National number
3 = Network SpeciÞc number
4 = Subscriber number
5 = Abbreviated number
0 = Unknown
1 = ISDN numbering plan
2 = Data numbering plan
3 = Telex numbering plan
4 = National standard numbering plan
5 = Private numbering plan
Note 1. The start port number of a PRI line is displayed. Thirty logic ports are automatically
assigned to a PRI line.
Each timer value of Layer3 is set up for each type in Program 81-06 (T-Bus) and Pro-
Note 2.
gram 82-06 (S-Bus).
Input Data
0 = 0.91V
1 = 0.74V
2 = 0.59V
3 = 0.42V
4 = 0.32V
5 = 0.21V
6 = 0.16V
7 = 0.10V
In long-haul mode
0 = 1.70V
1 = 0.84V
2 = 0.84V
3 = 0.45V
4 = 0.45V
5 = 0.20V
6 = 0.10V
7 = not deÞned
Default
0
0
0
0
3
1
Networking