Using A Handset As A Room Monitor - Siemens Gigaset S685 IP Manual

Using a handset as a room monitor

Using a handset as a room monitor
If the room monitor is activated, a previously stored destination number is
called as soon as a set noise level is reached in the room.
You can save an internal or external number in your handset as the destination
number.
The room monitor call to an external number is terminated after approximately
90 seconds. The room monitor call to an internal number (handset) stops after
approx. 3 minutes (depending on the base station). During use as a room mon-
itor, all keys are barred except for the end call key a. The handset's loud-
speaker is muted.
When the room monitor is activated, incoming calls to the handset are indi-
cated without a ringer and are only shown on the screen. The display and key-
pad are not illuminated and advisory tones are also turned off.
If you accept an incoming call, the room monitor is suspended for the duration
of the call, but the function remains activated.
If you deactivate then reactivate the handset, the room monitor remains acti-
vated.
Warning
u
You should always check the operation of the room monitor before
use. For example, test its sensitivity. Check the connection if you are
diverting the room monitor to an external number.
u
When the function is switched on, the handset's operating time is consider-
ably reduced. If necessary, place the handset in the charging cradle. This
ensures that the batteries do not run down.
u
Ideally the handset should be positioned 1 to 2 metres away from the baby.
The microphone must be directed towards the baby.
u
The connection to which the room monitor is diverted must not be blocked
by an activated answering machine.
Activating the room monitor and entering the destination number
¢
v í
¤
Change multiple line input:
Room M.
Select
Call to
External number:
¤
Select the number from the directory (press display key
it manually. Only the last 4 characters are displayed.
Internal number:
¤
Press the display key
Select
¤
Use s to select the handset or
be called) and press
138
¢
Room Monitor
to activate.
On
§Options§
INT and press
§OK§
§OK§
.
.
(if all registered handsets are to
Call All
.
Ò
) or enter