Changing The Name Of A Handset; Changing A Handset's Internal Number; Using A Handset As A Room Monitor - Siemens Gigaset E490 User Manual

Using a handset as a room monitor

Changing the name of a handset

The names "INT 1", "INT 2" etc. are
assigned automatically on registration.
You can change these names. The name
must be no more than 10 characters. The
changed name is displayed in every hand-
set's list.
u
Open the list of handsets. Your
own handset is indicated by <.
s
Select handset.
Press the display key.
§Edit§
~
Enter name.
Press the display key.
§Save§
Changing a handset's internal
number
A handset is automatically assigned the
lowest free number when it is registered.
If all slots are occupied, number 6 is over-
written if this handset is in idle status. You
can change the internal number of all reg-
istered handsets (1–6).
u
Open the list of handsets. Your
own handset is indicated by <.
Open menu.
§Options§
Edit H/Set No.
Select and press
handsets is displayed.
s
The current number flashes.
Select a handset.
~
Enter the new internal number
(1–6). The handset's old
number is overwritten.
Press the display key to save
§Save§
the input.
a
Press and hold (idle status).
You will hear the error tone (descending
tone sequence) if you assign an internal
number twice.
¤
Repeat the procedure with a free
number.
48
. The list of
§OK§
Using a handset as a
room monitor
If the room monitor is activated, a previ-
ously saved destination number is called
as soon as a set noise level is reached. You
can save an internal or external number in
your handset as the destination number.
The room monitor call to an external
number stops after around 90 seconds.
The room monitor call to an internal
number (handset) stops after approx. 3
minutes (depending on the base station).
When the room monitor is activated, all
keys are locked except the end call key.
The handset's speaker is muted.
When the room monitor is activated,
incoming calls to the handset are indi-
cated without a ringer and are only
shown on the screen. The display and key-
pad are not illuminated and advisory
tones are also turned off.
If you accept an incoming call, the room
monitor is suspended for the duration of
the call, but the function remains acti-
vated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.