Using Several Handsets; Registering Handsets - Siemens Gigaset S685 IP Manual

Using several handsets

Using several handsets

Registering handsets

You can register up to six handsets to your base station.
You can register your Gigaset S68H handset on up to four base stations.
When you register a new Gigaset handset, the base station transfers the follow-
ing entries to its local directory to enable you to use online directories on your
new handset:
u
Gigaset.net
Precondition: The handset can send and receive directory entries (see handset
user guide).
Successful registration is acknowledged with the message
received
Please note
u
If a number of handsets are registered on your base station, you can simul-
taneously make two calls via the Internet and one via the fixed line network
Up to two additional internal connections are also possible.
u
Selecting the line via the talk key (
handsets. This means that if you enter a number without a line suffix and
without defining a dialling plan for the phone number, it will be dialled via
Default Line
u
After registration, all the phone numbers for the phone will be assigned to
the handset as receive numbers. It will use the fixed line network number
and the first VoIP number as send numbers. For how to change the assign-
ments,
Registering another Gigaset S68H handset on the Gigaset S685 IP
Before you can use your handset, you must register it to the base station.
You must initiate handset registration on the handset and on the base station.
If the handset has been registered successfully, the handset returns to idle sta-
tus. The handset's internal number is shown in the display e.g.
repeat the procedure. Registration can take up to one minute.
¤
Select v
¤
Enter the system PIN of the base station (the default is 0000) and press
The display shows e.g.
¤
Within the next 60 seconds press and hold (for approx. 3 seconds) the reg-
istration/paging key (
132
for the Gigaset.net directory
for this reason.
£
( Page 157).
£
Page 193.
¢ ¢
Ð
Handset
Base 1
£
Page
£
Page 44) is not supported on GAP
¢
Register H/Set on the handset.
and flashes.
2) on the base station.
Data transfer x entries
1. If not,
Int
.
§OK§