Siemens Gigaset S685 IP Manual page 219

Registration or connection problems with a Bluetooth headset.
¥
Reset the Bluetooth headset (see the user guide for your headset).
¥
Delete registration data from the handset when de-registering the device
£
( Page 142).
¥
Repeat the registration process (
The display is blank.
1. The handset is not switched on.
¥
Press and hold the end call key
2. The battery is flat.
¥
Charge the battery or replace it (
The keys of a handset do not respond when pressed.
The keypad lock is activated.
¥
Press and hold the hash key
flashes on the display.
"Base X"
1. The handset is out of range of the base station or the base station's range has
decreased because Eco mode is active.
¥
Move the handset closer to the base station.
¥
Deactivate
Eco Mode
2. The handset has been de-registered.
¥
Register the handset (
3. The base station is not switched on.
¥
Check the base station's mains adapter (
4. An update of the base station firmware is currently being conducted (
Page 212).
¥
Please wait until the update is complete.
Base Search flashes on the display.
The handset is set to Best Base
¥
Move the handset closer to the base station.
¥
Check the base station mains adapter.
Handset does not ring.
1. The ringer is deactivated.
¥
Activate the ringer (
2. Call forwarding set to
¥
Deactivate call forwarding (fixed line network
Page 195).
You cannot hear a ringer/dialling tone from the fixed line network.
Base station's phone cord has been replaced.
¥
When purchasing a new cord, ensure that it has the correct jack pin connections
£
( Page 231).
Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.
¥
Re-enter system PIN.
Have you forgotten the system PIN?
¥
Reset the base station to set the system PIN back to 0000 (
£
Page 141).
a
.
£
Page
£
#
( Page
£
if necessary ( Page
£
Page 132).
£
and no base station is turned on or within range.
£
Page 151).
All Calls.
Service (Customer Care)
14).
36).
127).
Page 19).
£
Page 60; VoIP
£
Page
£
Page 158,
£
Page 63/
156).
217