Using A Handset As A Room Monitor - Siemens Gigaset SL78H Manual

Using a handset as a room monitor

Using a handset as a
room monitor
If the room monitor is activated, a previously
saved destination number is called as soon
as a set noise level is reached. You can save
an internal or external number in your hand-
set as the destination number. All of the
handset keys are deactivated, with the
exception of the display keys.
The room monitor call to an external
number stops after around 90 seconds. The
room monitor call to an internal number
(handset) stops after approx. 3 minutes
(depending on the base). When the room
monitor is activated, all keys are locked
except the end call key. The handset's
speaker is muted.
When the room monitor is activated, incom-
ing calls to the handset are indicated with-
out a ring tone and are only shown on the
screen. The display and keypad are not illu-
minated and advisory tones are also turned
off.
If you accept an incoming call, the room
monitor is suspended for the duration of the
call, but the function remains activated.
If you deactivate then reactivate the hand-
set, the room monitor remains activated.
38
Warning!
u
You should always check the opera-
tion of the room monitor before use.
For example, test its sensitivity.
Check the connection if you are
diverting the room monitor to an
outside number.
u
When the function is switched on, the
handset's operating time is considera-
bly reduced. If necessary, place the
handset in the charging cradle. This
ensures that the battery does not run
down.
u
Ideally the handset should be posi-
tioned 1 to 2 metres away from the
baby. The microphone must be
directed towards the baby.
u
The connection to which the room
monitor is forwarded must not be
blocked by an activated answering
machine.
Activating the room monitor and
entering the destination number
É
¢ ¢
v
Room Monitor
¤
Change multiple line input:
Activation:
Select On to activate.
Alarm to:
Select Internal or External.
External number: Select the number
from the directory (press display key
or enter it directly.
Internal number: Press the
¢
play key select handset or
registered handsets are to be called
¢
§OK§
.
The destination number or the internal
destination number is displayed in the
idle display.
Sensitivity:
Select noise level sensitivity (Low or
High).
¤
§Save§
Press to save the settings.
ö
)
§Change§
dis-
Call All, if all