Table of Contents
Advertisement
LED Pinspot Q4
Control Modes
There are 6 modes:
One LED Pinspot (Auto, Built-in programs and Manual)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the LED Pinspot is not connected with a DMX cable, it functions as a stand-alone device.
Please see pages 13–14 for more information about Auto, Built-in programs and Static colors.
One LED Pinspot (Sound-controlled)
01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Turn on the music. If the device is set to sound-control, then the LED Pinspot will react to the beat of
the music. Please see page 15 for more information about the sound-control options.
Multiple LED Pinspots (Master/Slave control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Use a 3-pin XLR cable to connect the LED Pinspots.
The pins:
03) Link the units as shown in Fig. 03. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units. You
can use the same functions on the master device as described on pages 13–15 (Auto, Built-in
programs, Static colors or Sound-controlled mode). This means that you can set your desired
operation mode on the master device and all slave devices will react the same as the master
device.
Multiple LED Pinspots (Master/Slave control)
Ordercode: 42407
●
Auto
●
Built-in programs
●
Static colors
●
Sound-controlled
●
Master/Slave
●
DMX-512 (4CH, 6CH, 8CH)
01)
Earth
02)
Signal -
03)
Signal +
8
Fig. 03
Advertisement
Table of Contents
