Table of Contents
Advertisement
LED Pinspot Q4
150-164
Color 11 (R000, G255, B255, W000)
165-179
Color 12 (R255, G255, B000, W080)
180-194
Color 13 (R255, G000, B000, W200)
195-209
Color 14 (R000, G255, B000, W200)
210-224
Color 15 (R000, G000, B255, W200)
225-239
Color 16 (R255, G180, B020, W080)
240-255
Color 17 (R255, G255, B255, W255)
Channel 7 – Program speed
0-255
Gradual speed adjustment, from slow to fast
Channel 7 – Sound sensitivity
0-255
Gradual sound sensitivity adjustment, from OFF to high sensitivity
Channel 8 – Strobe
0
Closed
1-255
Strobe flash frequency, from low to high frequency (0-20 Hz)
Maintenance
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by an expert after every year in the course of an acceptance test.
The operator has to make sure that safety-related and machine-technical installations are to be
inspected by a skilled person once a year.
The following points have to be considered during the inspection:
01) All screws used for installing the device or parts of the device have to be tightly connected and
must not be corroded.
02) There may not be any deformations on housings, fixations and installation spots.
03) Mechanically moving parts like axles, eyes and others may not show any traces of wearing.
04) The electric power supply cables must not show any damages or material fatigue.
The
LED Pinspot Q4
requires almost no maintenance.
Otherwise, the fixture's light output will be significantly reduced. Disconnect the mains power supply, and
then wipe the cover with a damp cloth. Do not immerse in liquid. Wipe lens clean with glass cleaner and
a soft cloth. Do not use alcohol or solvents.
The front lens will require weekly cleaning, as smoke-fluid tends to build up residues, reducing the light-
output very quickly.
Troubleshooting
No Light
If the light effect does not operate properly, refer servicing to a technician.
Suspect three potential problem areas as: the power supply, the LEDs, the internal fuse.
01) Power supply. Check if the unit is plugged into an appropriate power supply.
02) The LEDs. Return the LED Pinspot to your Showtec dealer.
03) The internal fuse. Return the LED Pinspot to your Showtec dealer.
04) If all appears to be O.K., plug the unit in again.
05) If you are unable to determine the cause of the problem, do not open the LED Pinspot, as this may
damage the unit and the warranty will become void.
06) Return the device to your Showtec dealer.
Ordercode: 42407
CH6 must be set between 25-249
CH6 must be set between 250-255
CH1 must be open; CH2-5 or CH6 must be open
However, you should keep the unit clean.
19
Advertisement
Table of Contents
