Multiple Led Pinspots (Dmx Control) - SHOWTEC LED Pinspot Q4 Manual

LED Pinspot Q4

Multiple LED Pinspots (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the LED Pinspots and other devices.
04) Link the units as shown in Fig. 04. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX signal cable. Repeat this process to link the second, third, and fourth units.
05) Supply electric power: Plug the mains power cords into proper electric power supply sockets,
starting with the first unit. Do not supply power before the whole system is set up and connected
properly.
Multiple LED Pinspots DMX Setup
Ordercode: 42407
Note : Link all cables before connecting electric power
9
Fig. 04