3.4.11 Initialization of parameter
▷
After resetting the parameter setting value, save initial parameter in FRAM.
▷
The stored value will be reset by pressing the SET key.
▷
The parameters fixed while setting the zero-point will remain the same.
SET
⇩
⇩
3.4.12 Initialization of position compensation
▷
After initializing the position compensation value to '0', save it in FRAM.
▷
Press the SET key and it will start initializing.
SET
⇩
⇩
; Press SET key and it will save the parameter.
; It will automatically save the parameters from 00 to 72.
⇘
; After saving to 72, it will resume to initial mode
; Press the SET key and it will save the parameter.
; It will automatically save the parameters from 00 to H7.
⇘
;
After saving to H7, it will resume to initial mode
DOOSAN SERVO
75