Table of Contents
Advertisement
⑤ Press SET key and the dot will appear below the first two segments. The data will be stored
and after a
while the dot will disappear and the display will turn back to the former status.
(When power is turned off and then turned on again, it will display the stored data.)
Set the zero-point from the zero-point display of the servo ON/OFF display mode.
① Press the MODE key and change the display to servo ON/OFF mode.
⇨
set parameter
set position compensation value
MODE
② Press the DOWN key and change the display to zero-point setting mode.
③ Press SET key for 5 seconds and the display will set the parameter automatically and the
turn back the display to zero-point setting mode.
Turn the power OFF and then ON again and the setting of the zero-point is now completed.
⇨
SET
⇨
⇨
SET
press for 10 secs.
⇨
⇨
status display
MODE
⇨
⇘
DOOSAN SERVO
⇨
servo on/off display
MODE
24
Hide quick links:
Advertisement
Table of Contents
