※ The alarm display and contents of the driver is as following.
OP Panel
main
LED Display
LED
▶
When the alarm goes on, the binary code of the main board LED display will output data through
position data output signal.
LED display
Alarm type
under voltage
:
occurs
when
the
voltage
is
below
the standard value.
over voltage :
occurs when
the
voltage
is
above
standard value.
main circuit error :
occurs
when the IPM malfunctions.
encoder signal error :
occurs
when
encoder
signal
malfunctions.
encoder
receive
initialization error :
occurs
when encoder is not initialized
over speed :
occurs
when
the motor speed exceeds the
maximum running count.
over load :
occurs when the
over load status continuous for
a
long
time
exceeding
standard time.
CPU error :
occurs
when
the
CPU
malfunctions
there is fault with the board.
parameter error :
occurs when
the set parameter is not within
the range.
excessive position deviation :
occurs
during
position
control
when
the
remaining
pulse
exceeds
the
fixed
value
parameter 19.
over current flow :
occurs if
the
over
current
flows
the motor.
encoder battery error :
occurs
when
the
backup
battery
of
the
encoder
discharged or disconnected.
Example) under voltage alarm
POSO3
POSO2
OFF
OFF
Corrective actions
- check if the input power is low.
- check if the motor power cable is open.
- check if the input power is high.
- check if the operation frequency is above
the
the standard value.
- check if regenerative resistor is damaged.
- check if the heat protection board is over
100 degrees celsius.
- check if the operation frequency is above
the standard value.
- check if the encoder connection is correctly
assembled.
- check if the encoder line is cut
data
- Drive turns the power off and then turns it
on 3 second later
- check if the encoder cable is missing or if it
correctly assembled.
- check if there is connection error in the
motor power cable.
the
- check if the parameter is set correctly.
or
- check if the parameter is set correctly.
- check if the parameter is set correctly.
- check if the value of parameter 18 is set
too low.
of
- check if the accel/decel parameter is set on
too low value.
into
- check if the insulation resistor of the motor
is correctly displayed.
- change the battery.
is
POSO3
OFF
DOOSAN SERVO
POSO3
ON
43