Doosan Vision DVSD-TA Series Operation Manual page 35


⑤ Press SET key and the dot will appear below the first two segments. The data will be stored.

If NC makes two points of contact (OVR0, OVR1) in a servo driver be fixed to "ON", the servo
driver makes two points of contact (AUX_OUT0, AUX_OUT1) be fixed to "ON".
Then, Home Machine of the servo driver proceed

Turn the power OFF and then ON again and the setting of the zero-point is now completed.
⇨ ⇨ ⇨
SET
⇨ ⇨
⇘
DOOSAN SERVO
⇨
30