Table of Contents
Advertisement
Get started with XBee Zigbee
For XBee SMT modules, align all XBee pins with the spring header and carefully push the
module until it is hooked to the board.
2. Once the XBee module is plugged into the board (and not before), connect the board to your
computer using the micro USB cables provided.
3. Ensure the loopback jumper is in the UART position.
4. Connect an antenna (if applicable).
How to unplug an XBee device
To disconnect your XBee device from the XBee Grove Development board:
1. Disconnect the micro USB cable (or the battery) from the board so it is not powered.
2. Remove the XBee device from the board socket, taking care not to bend any of the pins.
CAUTION! Make sure the board is not powered when you remove the XBee device.
XBee® Zigbee® Mesh Kit
Assemble the hardware
22
Advertisement
Table of Contents
Need help?
Do you have a question about the XBee Zigbee Mesh Kit and is the answer not in the manual?