Digi XBee ZigBee Cloud Kit Quick Start Manual

Quick Start Guide
XBee ZigBee Cloud Kit

2Write down the serial numbers

Write down the serial number located on the back of your XBee Gateway and XBee RF module. You will use these serial numbers later when
accessing the gateway and adding the devices to Digi Device Cloud. Some digits of the serial number are the same for all models and are
pre-filled below.
XBee Gateway serial number:
00409D______________

3Connect the hardware

Connect XBee Gateway hardware
1. Connect the power supply.
2. Optional: If you are using an Ethernet network connection in addition to Wi-Fi, connect one end of the
© 2016 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this
document are the property of their respective owners.

1Verify your components

The Digi™ XBee® ZigBee® Cloud Kit allows you to set up your XBee Gateway, development
board and XBee module, and configure the XBee Gateway web interface through your Wi-
Fi network. You can then see sensor data from your hardware kit on the web page and
send data from the web to your device.
Included equipment continued
XBee RF module:
0013A200______________
Included equipment
Required additional equipment