Table of Contents
Advertisement
Step 3: Configure the XBee modules
XBee B and XBee C, the routers, send the digital value from the user button to XBee A, the coordinator, every time the value changes (that is, when you
press or release the button).
Set the destination address (DH + DL) of the senders (XBee B and XBee C) to the MAC address (SH + SL) of the receiver (XBee A). Additionally, configure
the pin where the button is connected (DIO4/AD4) as a digital input, and set the DIO change detect (IC) to monitor the same pin.
Advertisement
Table of Contents
Need help?
Do you have a question about the XBee Zigbee Mesh Kit and is the answer not in the manual?