Parameters; General Parameters - Gira 5142 00 Product Documentation

4.2.5 Parameters

4.2.5.1 General parameters

Description
h General
Transmit delay after
reset or bus voltage
return
Colour selection of all
status LEDs
Light period of status
LED for button-press
indicator
Order No. 5142 00
Order No. 5145 00
Values
Yes
No
red
green
blue
Colour selection per rocker
switch/button
1 sec
2 sec
3 sec
Software "Push button sensor 3 plus"
Comment
After the application program or the
physical address is loaded or after the
bus voltage is switched on, the push
button sensor for the room temperature
controller extension unit can transmit
telegrams automatically. The push
button sensor then requests from the
room temperature controller the current
state for all the transmitting objects with
the name "B.Controller extension" and
for the objects "D.Input controller
extension". After a device reset, the
telegrams for room temperature
measurements (external sensor) are
also automatically transmitted to the
bus.
If there are still other bus devices
besides the push button sensor
transmitting telegrams immediately after
a reset, it may be useful to activate the
transmit delay for automatically
transmitting objects in order to reduce
the bus load.
When transmit delay is activated
(setting: "Yes"), the push button sensor
computes the time delay from its device
ID in the physical address. The sensor
then waits 30 seconds maximum before
transmitting telegrams.
The colour of the status LED can be
selected here. In the colour
configuration a distinction is made
between whether all of the status LEDs
of the push button sensor have the
same colour (setting "red", "green" or
"blue"), or whether alternatively various
colours can be configured for the LEDs
("Colour selection per rocker
switch/button" setting). With colour
selection per rocker switch or button it is
possible to set the colour on the
parameter pages of the individual status
LEDs.
This parameter defines the switch-on
time the status LED is lit up to indicate
actuation. The setting concerns all
status LEDs whose function is set to
Parameters
Page 199 of 281