Menu "Settings - Gira 5142 00 Product Documentation

Installation, electrical connection and operation

2.5.3 Menu "Settings"

Main menu
Without using the ETS, the two display buttons of the device can be used to perform various
device settings and also to execute operating functions. For example, it is possible to configure
the room temperature controller (operating mode switchover, setting the setpoint temperatures)
and to set the heating timer and the display contrast. Furthermore, if a fan controller is present
the fan levels can be set manually.
In order to avoid the unintentional disruption of essential functions of the device, access to
individual settings can be prevented via the parameterisation in the ETS. When the button
disabling function is active, access to the settings is completely blocked.
The settings can be changed using the display buttons both on a main controller or also on
controller extensions. The setting options on the controller extensions are limited, however.
The configuration menu is called up if the normal display is active and at the same time the left
and right mouse buttons are pressed. After that the menu "Settings" is displayed (Figure 9). The
selection can be confirmed by pressing the the right-hand display button >. Pressing the left-
hand display button x aborts the configuration menu. The display then returns to the normal
display.
If the selection is confirmed, the display then shows the main menu. Depending on the enabling
settings in the ETS, various menu entries are shown, which can be selected using the buttons
n and o.
A selected menu entry can be opened by pressing both of the OK display buttons. The display
then goes to the corresponding submenu.
The main menu can be exited by selecting and confirming the entry "Abort". Alternatively the
main menu will be exited if no further input is made for approx. 15 seconds.
Order No. 5142 00
Page 20 of 281
Order No. 5145 00