Connector Of The 120 Ω E1 Station Clock Output Cables - Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual

System cabling and final assembly
TI-E1 Station clock I/O interface (120 Ω)
...................................................................................................................................................................................................................................
Cable quantity
One input cable and one output cable are needed for each Timing Interface (TI).
Cable data (TI-E1 Output, 120 Ω)
Length of pre-fabricated cables, shielded twisted pair, 120 Ω + overall screen:
• 10 m [32.808 ft] Station clock output cable, TI–E1 (120Ω) — CC109155556
• 25 m [82.021 ft] Station clock output cable, TI–E1 (120Ω) — CC109155564
• 50 m [164.042 ft] Station clock output cable, TI–E1 (120Ω) — CC109155572
• 75 m [246.063 ft] Station clock output cable, TI–E1 (120Ω) — CC109164244
• 100 m [328.084 ft] Station clock output cable, TI–E1 (120Ω) — CC109164251.
Connector data (TI-E1 Output, 120 Ω)
The 120 Ω E1 station clock output cables have a 9-pin SUB-D connector (male).
Figure 4-42 Connector of the 120 Ω E1 station clock output cables
Table 4-16
Point on
connector
5, 6
...................................................................................................................................................................................................................................
4-66
Pin assignment (E1 station clock output cables, 120 Ω)
Signal name
2 Station-Clock Output Positive
3 Station-Clock Output Negative
7 Ground
Strap
Alcatel-Lucent - Proprietary
See notice on first page
Wire Wire color *1
a-wire / Tip White
b-wire / Ring Blue
Screen
365-374-179R10.0
Issue 2, June 2009