Procedure A-7: Circuit Pack Alarm Handling - Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual

Installation troubleshooting

Procedure A-7: Circuit pack alarm handling

...................................................................................................................................................................................................................................
Overview
The procedure described below should be performed if the "Fault" LED is flashing on
one or more circuit packs or if circuit pack alarms are displayed in the WaveStar
alarm list after a system reset.
Required equipment
Prior to performing this task, the following equipment must be available:
1. WaveStar
2. CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4,
4-48, "CIT connection (LAN crossed)" (p.
Prerequisites
Prior to performing this task, you must:
1. be logged in to WaveStar
2. be logged in to the NE.
Procedure
Proceed as follows to perform a circuit pack reset:
...................................................................................................................................................................................................
In the WaveStar
1
Result:
...................................................................................................................................................................................................
Specify the slot where the corresponding circuit pack resides by selecting the slot from
2
the equipment selection tree on the left-hand side of the
window. Alternatively, you may also enter the slot AID directly into the
field.
...................................................................................................................................................................................................
Click Select
3
...................................................................................................................................................................................................
Select
4
window.
...................................................................................................................................................................................................
Click Apply
5
...................................................................................................................................................................................................................................
A-12
®
CIT PC
®
CIT
System View
The
Reset Slot/Circuit Pack
.
as
Controller Reset Type
and then Yes in the confirmation window.
Alcatel-Lucent - Proprietary
4-73))
®
CIT as Super User.
, select
Fault
window appears.
on the right-hand side of the
See notice on first page
→ →
Reset Slot/Circuit Pack{
Reset Slot/Circuit Pack
Reset Slot/Circuit Pack
®
CIT
Figure
.
Enter AID
365-374-179R10.0
Issue 2, June 2009