Rack Line-Up Without Rack Extensions (Width) - Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual

Mechanical installation
...................................................................................................................................................................................................
4
IF ...
rack extensions (width) are not
used
rack extensions (width) are used
...................................................................................................................................................................................................
Put the bushings (= spacers) for adapter kit (CC848316279, item 1) in the rack frame
5
or rack extension and fix them by using CH SCR, STL ST-70, M4x25 screws
(CC847117900, item 2) and STL, ST-70-140HV, 4.3x12 washers (CC847174950, item
3) in each nut retainer position as shown in the figures below.
...................................................................................................................................................................................................
Tighten the CH SCR, STL ST-70, M4x25 screws (CC847117900, item 2).
6
E
N D O F
...................................................................................................................................................................................................
Layout
Figure 3-11 Rack line-up without rack extensions (width)
....................................................................................................................................................................................................................................
3-20
S T E P S
Alcatel-Lucent - Proprietary
See notice on first page
THEN ...
place the rack frame (item 4) of the extension rack
next to the existing rack.
place the rack extension of the extension rack next
to the rack extension (item 5) of the existing rack.
Procedure 3-6: Rack adapter kit
365-374-179R10.0
Issue 2, June 2009