Procedure 8-1: Led Test - Alcatel-Lucent 1675 LambdaUnite Installation And System Turn-Up Manual

Stand-alone test procedures

Procedure 8-1: LED test

...................................................................................................................................................................................................................................
Overview
This test ensures the functionality of the LEDs on all circuit packs as well as on the
User Panel. The "PWR ON" LED on the User Panel and the fan unit LEDs are not
affected by the LED test.
Test procedure
Proceed as follows to perform an LED test:
...................................................................................................................................................................................................
Push the "LED TEST" button on the User Panel to test the circuit pack and User Panel
1
LEDs.
PWR ON
CIT (LAN)
Result:
seconds.
E
N D O F
...................................................................................................................................................................................................
LED test failure
In the case of an LED test failure (not all LEDs illuminate), please refer to appendix
A, section
...................................................................................................................................................................................................................................
8-2
User Panel
NE ACTY
CR
FE ACTY
MJ
ACO
MN
LED TEST
ABN
All circuit pack and User Panel LEDs should illuminate for about three
S T E P S
Procedure A-8: "LED test failure" (p.
Alcatel-Lucent - Proprietary
See notice on first page
A-14).
365-374-179R10.0
Issue 2, June 2009