...................................................................................................................................................................................................................................

Overview

The tests described below verify that currently active alarms of the system are reported

to the WaveStar

at the rack top (front and rear). The tests include raise and clear behavior of the alarms

created.

Required equipment

Prior to performing this task, the following equipment must be available:

1. WaveStar

2. CAT5 crossover LAN cable with RJ-45/RJ-45 connectors (see chapter 4,

4-48, "CIT connection (LAN crossed)" (p.

3. ESD Wrist Strap.

Prerequisites

Prior to performing this task, you must have done the following:

1. Logged in to WaveStar

"Starting the WaveStar

has been enabled during WaveStar

2. Logged in to the NE.

Minor alarm test

Electronic components can be destroyed by electrostatic discharge.

Always observe the ESD instructions (cf.

Proceed as follows to check the "Minor" alarm reporting:

...................................................................................................................................................................................................

Remove the "POWER INPUT A" cable from the fan unit. You can do this without

switching off the power supply.

365-374-179R10.0

Issue 2, June 2009

CIT, to the User Panel and to the rack alarm lamps that are located

CIT PC

CIT as Super User (see chapter 5, section

CIT application" (p.

CAUTION

ESD hazard

Alcatel-Lucent - Proprietary

See notice on first page