Installing The Cutting Units - Toro Reelmaster 7000-D Operator's Manual

1. Bolt
2. Nut
9. Tighten the bolt securely but do not tighten the
nut.
4

Installing the Cutting Units

Parts needed for this procedure:
1 Front hose guide (right)
1 Front hose guide (left)
Procedure
1. Remove the reel motors from the shipping
brackets.
2. Remove and discard the shipping brackets.
3. Remove the cutting units from the cartons.
4. Assemble and adjust as described in the cutting
unit Operator's Manual.
5. Make sure that the counter weight
installed to the proper end of the cutting unit as
described in the cutting unit Operator's Manual.
Figure 8
3. Arm of the hood-lock
bracket
(Figure
g012631
1. Counter weight
6. All of the cutting units are shipped with the turf
compensation spring mounted to the right side
of the cutting unit. The turf compensation spring
must be mounted to the same side of the cutting
unit as the reel drive motor. Reposition the turf
compensation as follows:
A. Remove the 2 carriage bolts and nuts
securing the rod bracket to the cutting-unit
tabs
1. Turf compensation spring
2. Rod bracket
9) is
B. Remove the flange nut securing the
spring-tube bolt to the carrier-frame tab
(Figure
C. Remove the assembly.
D. Mount the spring-tube bolt to the opposite
tab on the carrier frame and secure with the
flange nut.
Note:
side of the tab as shown in
13
Figure 9
(Figure 10).
Figure 10
3. Spring tube
10)
Position the bolt head to the outer
g003320
g003949
Figure 11.