Cleaning The Fuel-Intake Screen; Electrical System Maintenance; Electrical System Safety; Charging And Connecting The Battery - Toro Reelmaster 7000-D Operator's Manual

Figure 82
1. Fuel-filter head
3. Remove the filter and clean the filter-head
mounting surface
4. Lubricate the filter gasket with clean lubricating
engine oil. Refer to the engine owner's manual,
included with the machine, for additional
information.
5. Install the dry filter canister, by hand, until the
gasket contacts the filter head, then rotate it an
additional 1/2 turn.
6. Start the engine and check for fuel leaks around
the filter head.
Cleaning the Fuel-Intake
Screen
Park the machine on a level surface, lower the cutting
units, engage the parking brake, shut off the engine,
and remove the key.
The fuel-intake tube, located inside the fuel tank, is
equipped with a screen to help prevent debris from
entering the fuel system. Remove the fuel-intake tube
and clean the screen as required.
2. Fuel filter
(Figure 82).
Electrical System
Maintenance

Electrical System Safety

•
Disconnect the battery before repairing the
machine. Disconnect the negative terminal first
and the positive last. Connect the positive terminal
first and the negative last.
•
Charge the battery in an open, well-ventilated
area, away from sparks and flames. Unplug the
charger before connecting or disconnecting the
battery. Wear protective clothing and use insulated
tools.
g021291
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead
compounds, chemicals known to
the State of California to cause
cancer and reproductive harm. Wash
hands after handling.
Charging and Connecting
the Battery
1. Park the machine on a level surface, lower the
cutting units, engage the parking brake, shut off
the engine, and remove the key.
2. Unlatch and raise the operator's console panel
(Figure 83).
57
WARNING
CALIFORNIA