Maintenance; Recommended Maintenance Schedule(S) - Toro Reelmaster 7000-D Operator's Manual

Maintenance

Note:
Determine the left and right sides of the machine from the normal operating position.

Recommended Maintenance Schedule(s)

Maintenance Service
Interval
After the first 8 hours
After the first 200 hours
Before each use or daily
Every 50 hours
Every 100 hours
Every 200 hours
Every 250 hours
Every 400 hours
Every 800 hours
Every 6,000 hours
Before storage
Maintenance Procedure
• Torque the wheel nuts.
• Change the front planetary-gear oil.
• Change the oil in the rear axle.
• Change the hydraulic filters.
• Check the cooling system.
• Check the tire pressure.
• Check the interlock switches.
• Check the engine-oil level.
• Drain water or other contaminants from the water separator.
• Remove debris from the engine area, oil cooler, and radiator.
• Check the level of the hydraulic fluid.
• Inspect the hydraulic lines and hoses for leaks, kinked lines, loose mounting
supports, wear, loose fittings, weather deterioration, and chemical deterioration.
• Grease the bearings and bushings.
• Check the battery condition.
• Check the condition and tension of the alternator belt.
• Torque the wheel nuts.
• Change the engine oil and filter.
• Service the air cleaner. Service the air cleaner earlier if the service indicator shows
red. Service it more frequently in extremely dirty or dusty conditions.
• Check the fuel lines and connections for deterioration, damage, or loose connections.
• Replace the fuel filter canister.
• Replace the engine fuel filter.
• Check for end-play in the planetary drives.
• Check the planetary-gear-drive oil level (check if you notice external leakage).
• Check the oil level of the rear axle.
• Check the lubricant in the gear box of the rear axle.
• Drain and clean the fuel tank.
• Change the front planetary-gear oil or yearly, whichever comes first.
• Change the oil in the rear axle.
• Check the rear-wheel toe-in.
• Change the hydraulic fluid.
• Change the hydraulic filters.
• Disassemble, clean, and assemble the soot filter of the DPF or clean the soot
filter if engine faults
SPN
in the InfoCenter.
• Drain and clean the fuel tank.
• Check the tire pressure.
• Check all fasteners.
• Grease or oil all grease fittings and pivot points.
• Paint chipped surfaces.
3720 16, 3720
FMI SPN FMI
47
0, or 3720 16 display
SPN FMI