Installing The Grass-Basket Hooks; Installing The Cutting Units - Toro Greensmaster eTriFlex 3370 Operator's Manual

1. Steering wheel
2. Washer
11. Torque the locknut to 27 to 35 N∙m (20 to 26
ft-lb).
12. Install the cap to the wheel.
5
Installing the Grass-Basket
Hooks
Parts needed for this procedure:
6 Grass-basket hook
12 Flange bolts
Procedure
Use 12 flange bolts to install 6 grass-basket hooks
onto the ends of the suspension-arm bars
1. Flange bolt
2. Grass-basket hook
Figure 8
3. Locknut
4. Cap
(Figure
Figure 9
3. Suspension-arm bar
6

Installing the Cutting Units

Parts needed for this procedure:
Cutting unit (order separately; contact your authorized
3
Toro distributor)
3
Grass basket
g010834
3 Electric counterweight
6 Capscrew
3 O-ring
Procedure
1. Prepare the cutting units for installation; refer to
your cutting unit Operator's Manual.
2. Apply grease to the inside spline of the drive
coupler.
3. Install an O-ring to each reel motor as shown
in Figure
9).
4. Secure the electrical counterweight to the
existing counterweight with 2 capscrews as
g015492
shown in
11
10.
Figure 10
Figure 11.
g256064