Checking The Hydraulic System - Toro Reelmaster 7000-D Operator's Manual

Biodiesel
This machine can also use a biodiesel blended fuel of
up to B20 (20% biodiesel, 80% petroleum diesel).
Sulfur content: Ultra-low sulfur (<15 ppm)
Biodiesel fuel specification: ASTM D6751 or
EN14214
Blended fuel specification: ASTM D975, EN590,
or JIS K2204
Important:
The petroleum diesel portion must
be ultra-low sulfur.
Observe the following precautions:
•
Biodiesel blends may damage painted surfaces.
•
Use B5 (biodiesel content of 5%) or lesser blends
in cold weather.
•
Monitor seals, hoses, gaskets in contact with fuel
as they may be degraded over time.
•
Fuel filter plugging may be expected for a time
after converting to biodiesel blends.
•
Contact your Authorized Toro Distributor if you
wish for more information on biodiesel.
Adding Fuel
1. Position the machine on a level surface, lower
the cutting units, shut off the engine, and remove
the key.
2. Using a clean rag, clean the area around the
fuel-tank cap.
3. Remove the cap from the fuel tank
1. Fuel-tank cap
4. Fill the tank until the level is to the bottom of the
filler neck with fuel.
5. Install the fuel-tank cap tightly after filling the
tank.
Note:
If possible, fill the fuel tank after each use.
This minimizes possible buildup of condensation
inside the fuel tank.
Checking the Hydraulic
System
Before you start the engine and use the machine,
check the hydraulic system; refer to
Level of the Hydraulic Fluid (page
28
(Figure
Figure 34
Checking the
67).
34).
g200372