Toro Reelmaster 7000-D Operator's Manual page 9

Note:
This machine complies with the industry standard stability test in the static lateral and longitudinal tests with the maximum
recommended slope indicated on the decal. It is important that each operator review the slope operations instructions in the operator
manual and review the conditions in which the machine is being operated to determine if the machine may be operated in the conditions
that day and on that site. Changes to terrain can result in a change in slope operation for any machine.
1. Warning—read the Operator's Manual; do not operate the
machine unless you have received training.
2. Warning—read the Operator's Manual before towing the
machine.
3. Tipping hazard—do not turn at high speeds; do not drive up
or down slopes greater than 16 degrees; do not drive across
slopes greater than 22 degrees; lower the cutting units when
driving down slopes; use a roll over protection system and
wear the seat belt.
120-1686
(Affix over Part No. 120-1683 for CE)
4. Warning—do not park the machine on slopes; engage the
parking brake, lower the cutting units, shut off the engine, and
remove the ignition key before leaving the machine.
5. Thrown object hazard—keep bystanders a safe distance
away from the machine.
6. Entanglement hazard, belt—stay away from moving parts,
keep all guards and shields in place.
9
decal120-1686