Lubrication; Greasing The Bearings And Bushings - Toro Reelmaster 7000-D Operator's Manual

Lubrication

Greasing the Bearings and
Bushings
Service Interval: Every 50 hours
The machine has grease fittings that must be
lubricated regularly with No. 2 lithium grease. If
the machine is operated under normal conditions,
lubricate all bearings and bushings after every 50
hours of operation or immediately after every washing.
The grease fitting locations and quantities are as
follows:
•
Brake shaft pivot bearings (5)
Figure 67
•
Rear axle pivot bushings (2)
Figure 68
(Figure 67)
g009704
(Figure 68)
g009705
51
•
Steering cylinder ball joints (2)
Figure 69
1. Top fitting on king pin
•
Tie rod ball joints (2)
•
King pin bushings (2)
on the king pin should only be lubricated
annually (2 pumps).
•
Lift arm bushings (1 per cutting unit)
Figure 70
•
Lift cylinder bushings (2 per cutting unit)
70)
•
Lift arm pivot bushings (1 per cutting unit)
71)
(Figure 69)
(Figure 69)
(Figure 69). The top fitting
(Figure
(Figure
(Figure
g009706
70)
g015159