Toro Reelmaster 7000-D Operator's Manual page 16

1. Snapper pin
Note:
Fixed steering is recommended when
cutting on side hills.
13. Use the following procedure on the rear cutting
units when the height of cut is above 19 mm
(3/4 inch).
A. Remove the lynch pin and washer securing
the lift-arm pivot shaft to the lift arm and
slide the lift-arm pivot shaft out of the lift
arm (Figure
1. Lift-arm pivot-shaft lynch pin and washer
B. Insert the lift-arm yoke onto the carrier
frame shaft
C. Insert the lift-arm shaft into the lift arm and
secure it with the washer and the lynch pin
(Figure 18).
14. Secure the lift-arm chain to the chain bracket
with the snapper pin
Note:
Use the number of chain links described
in the cutting unit Operator's Manual.
Figure 17
18).
Figure 18
(Figure 16).
(Figure 19).
1. Lift-arm chain
g015977
2. Chain bracket
15. Coat the spline shaft of the reel motor with clean
grease.
16. Oil the reel motor O-ring and install it onto the
motor flange.
17. Install the motor by rotating it clockwise so that
the motor flanges clear the bolts
g003979
1. Reel-drive motor
18. Rotate the motor counterclockwise until the
flanges encircle the bolts, and then tighten the
bolts.
Important:
hoses are not twisted, kinked, or at risk of
being pinched.
16
Figure 19
3. Snapper pin
(Figure
Figure 20
2. Mounting bolts
Make sure that the reel motor
g003948
20).
g004127