Toro Reelmaster 7000-D Operator's Manual page 44

Figure 61
1. Rear traction manifold
(behind front left wheel)
2. Connect a hydraulic hose between the
diagnostic fitting installed in the rear traction
manifold and the reverse traction pressure test
port (Figure 62).
Note:
Use the hydraulic fittings and coupler
fittings as needed to install the hose.
Figure 62
1. Reverse traction pressure
test port
3. Rotate the bypass valve 90° (1/4 turn) in either
direction to open it and allow fluid to bypass
internally (Figure
Note:
Because the fluid bypasses the
transmission, you can move the machine slowly
without damaging the transmission.
Note the position of the valve when opening and
closing it.
2. Unmarked port
2. Hydraulic fluid return filter
63).
1. Bypass valve
g033131
4. When you are finished pushing or towing the
machine, remove the hydraulic hose that you
installed.
5. Install the existing cap onto the reverse traction
pressure test port.
6. Install the diagnostic-fitting cap onto the fitting
that you installed on the manifold.
7. Rotate the bypass valve 90° (1/4 turn) back
before starting the engine.
Note:
Do not exceed 7 to 11 N∙m (5 to 8 ft-lb)
torque to close the valve.
Pushing or Towing the Machine
Forward Only
If you need to push or tow the machine forward only,
you can just rotate the bypass valve.
Important:
If you need to push or tow the
machine in reverse, refer to
for Pushing or Towing in Reverse (page
1. Open the hood and remove the center shroud.
2. Rotate the bypass valve 90° (1/4 turn) in either
g033132
direction to open it and allow fluid to bypass
internally
Note:
Because the fluid bypasses the
transmission, you can move the machine
forward slowly without damaging the
transmission.
Note the position of the valve when opening and
closing it.
3. Rotate the bypass valve 90° (1/4 turn) back
before starting the engine.
Note:
Do not exceed 7 to 11 N∙m (5 to 8 ft-lb)
torque to close the valve.
44
Figure 63
Preparing the Machine
(Figure 63).
g009703
43).