Chapter 3: Setup; Adjusting The Front Cutting Unit Roller Position; Installing The Cutting Units; Preparing The Machine - Toro Reelmaster 7000-D Operator's Manual

Adjusting the Front Cutting Unit Roller
1
Position
Check all cutting unit roller positions and adjust if
needed.
• For 27-inch cutting units, use the upper
mounting holes
• For 32-inch cutting units, use the lower
mounting holes

Installing the Cutting Units

2
Parts Required
1
1

Preparing the Machine

Remove the shipping brackets from the reel motors and discard.
3466-702 A
of the roller support
of the roller support.
Right front hose guide
Left front hose guide
.
G419213
Page 3–1
Chapter 3
Setup
Setup